F-101 Voodoo plans

1 review for F-101 Voodoo plans

1. 

   Rated 5 out of 5

   Tobias “Tigger” Gaus – 22nd November 2021

   Thanks Craig for the drawing of the plans and the 3D files.
   The Voodoo was on my “build list” quite for a while 😉

   Building:
   Again the build is not so difficult. it needs quite some sanding…
   for the bulkheads I also decided to use poplar wood (like on my other Jetworks models)
   For the outlet and the inlet tube I went for the regular PLA to get ridgit ductings.
   All other 3D printed parts are printed with LW-PLA (to keep the weight low)
   I had to cut the inlet ring on my FMS 70mm EDF, as it´s seems now a part of the housing ;(

   Flying:
   On the first flight the controls have been way to big. (on the elevator)
   CG was spot on.
   //www.youtube.com/watch?v=xjw2_HuRMos
   next flight on a windy day, with reduced elevator throws
   //www.youtube.com/watch?v=hAUv8d8b_gM&t=32s

   Setup:
   EDF 70mm FMS (4s version)
   4s 3300mAh Lipo
   CG at 100mm from the leading edge
   elevator 8mm up/down (60%Expo)
   ailerons 14mm up/down (40%Expo)

   It is still very sensitive on pitch, due to the full flying elevator

   “Tigger”