Loading file
  • Fullscreen
  • Wireframe
  • Zoom In
  • Zoom Out
  • Rotation
  • Screenshot
  • Help

Controls

×
  • Rotate with the left mouse button.
  • Zoom with the scroll button.
  • Adjust camera position with the right mouse button.
  • Double-click to enter the fullscreen mode.
  • On mobile devices swipe to rotate.
  • On mobile devices pinch two fingers together or apart to adjust zoom.
  • On mobile devices 3 finger horizontal swipe performs panning.

Harrier GR5,7 and 9 Canopy Vacuum forming tool .stl

£1.42

Categories: ,

Description

Please note THIS IS NOT A CLEAR CANOPY – it is a tool or ‘Buck’ to make a canopy.

Designed to sit flat on a vacuum forming bed.   Print with 5 Layer wall and zero infil.

Cut a large hole in the base, and remove the infill matrix.

Fill completely with plaster of paris.  60g of water to 100g Plaster.   Most canopy tools take about 4-500g of plaster.  Allow several days to dry – left with the belly up.

Once set, sand the 3d printed surface smooth using finer and finer grades of Wet n Dry paper – use Automotive filler primer aerosol to help get a good surface.

Polish with a rubbing compound such as T-Cut, then buff with a cloth and water to get a polished finish.

Please note that this mould tool has undercut, so will need careful releasing. Using a thinner canopy plastic (<.5mm) and perhaps cutting the canopy plastic where it will be trimmed away anyway will help.

Reviews

There are no reviews yet.

Be the first to review “Harrier GR5,7 and 9 Canopy Vacuum forming tool .stl”

Your email address will not be published. Required fields are marked *