Harrier Plans

(1 customer review)


Harrier Plans

Categories: ,


Test Pilot :  Craig ‘Clickety’ Clarkstone

Included in the plans are the following versions :
GR1, GR3, GR5, GR7, GR9,  Sea Harrier.

Designed for a single pusher motor or single 64mm EDF.

This is for plans only.  Once purchased you will receive a download link to a zipped file.  the PDF files will be within it.

^ See the Build guide in the Tabs above ^



Build Guide

Harrier Construction Guide_2021-01-09

Power options

NOTE : These links will open in another tab.

Single Pusher (3s)








Sea Harrier_GA_2021-1-16

Build log

Build log


1 review for Harrier Plans

  1. Barry Fleming

    An amazing jet, or another amazing jet from Craig……!

    Normally i would give it a few days flying to get the feel for this design but after smoking 4 batteries with her after the maiden … i just couldn’t get enough 🙂
    i built this one as a pusher version of the GR7
    balanced out on the marked CG but think she could go back a couple mm yet and will try. rolls on the axis with no elevator input very well. loops are good and nice and lazy however she will turn if needed.
    added the 3D printed nose, intakes and exhaust tubes. clear canopy from Jetworks set’s her of looking fantastic
    1400 mAh 4s
    40 amp ESC
    Emax 2205s 2600kv
    9×6 CF prop
    3x9g MG servos
    superb looking, flying, stable and acrobatic model when needed

    Love this Design

Add a review

Your email address will not be published. Required fields are marked *