Jas-39 Gripen plans

(1 customer review)

£3.61

Gripen

Categories: ,

Description

TEST PILOT : Barry Fleming

Read the review for setup details.

Designed for either 70mm or 64mm EDF,  or Single Pusher.

Check out the Build Guide in the tabs above and don’t forget to watch Barry Flemings fantastic build video :-

WIKI

//en.wikipedia.org/wiki/Saab_JAS_39_Gripen

 

Build Guide

Gripen Build guide_2021-07-22

Power Options

NOTE : These links will open in another tab.

Single Pusher (3s) – Used as a dual pusher setup

64mm EDF (4s)

 

Videos

Specs

Gripen GA_2021-07-19

Build log

1 review for Jas-39 Gripen plans

  1. Barry Fleming

    Wahoooo
    The Gripen is one of my favourite jets and dam she flies like she is…!

    Built at 100% including the 3D printed parts that i just love
    Very easy build guide to follow.
    Set up on FMS 70mm (6s) overpowered yes but epic 🙂 im more than confident if i went for my usual 64/70mmFMS 4s she would have flown just as good
    80amp ESC i would recomend 40-60amp would be fine on lower power train set up.
    2650mAh 6s oh and it sounds amazing
    3x 9g MG servos (1 operating Canard) and other two on Elevon set up.
    fly’s really well on estimated CG however im currently working my way back slightly as i think she could go there a bit more.
    Travel on Elevons / Aileron 18mm +/-
    Travel on Elevons / Elevator 20mm +/-
    Canard Travel at Trailing Edge 15mm +/-
    CG im flying on 120mm from leading edge and pushing further back next flight to see
    With the Delta wing im sure she will be forgiving with the CG
    hoping to try out high alpha next
    The 3D parts are fantastic addition especially when you add the 3D cockpit and pilot! I urge you to purchase a clear canopy as it looks absolutely stunning for the finish.
    Another New Favourite Jet
    maiden was uneventful in 15MPH wind however the below link is 3 batteries in to flying the JAS-39 nand LOVING it
    //www.youtube.com/watch?v=EXljkOYEO8c

Add a review

Your email address will not be published. Required fields are marked *