A4 Skyhawk Plans

(2 customer reviews)


Test Pilot : Rod Nordsvan (Australia)

Thanks everyone for sharing your images

A4 Skyhawk Plans

Categories: ,


The A4- Skyhawk was designed to accept  either a single EDF (64-70mm) or a pusher

This is for plans only.  Once purchased you will receive a download link to a zipped file.  the PDF files will be within it.

^ See the Build guide in the Tabs above ^




Build Guide


Skyhawk RAN Decals-2 donated by Rod Nordsvan

Power options

NOTE : These links will open in another tab.

Single Pusher (3s)

64mm EDF (3s)

64mm EDF (4s)

70mm EDF (4s)

EDF – 70mm (4s)




700mm wingspan


Build log


2 reviews for A4 Skyhawk Plans

  1. Rod Nordsvan

    It flew like it was on rails right off the bungee launcher, just needed some right aileron trim and a little down elevator and it was cruising beautifully. Extremely stable in level flight and very predictable doing basic aerobatics (rolls, loops, reversals etc.)My final set up is as follows:CG is 250mm forward of the trailing edge of the wing at the root.Throws for the ailerons are up & down 10mm, the elevators up & down 15mm .My motor is a: Turnigy L2210-1650 Bell Style Motor (250w), Hobbyking 50A ESC, Hobbyking 939MG servos & a 7 x 6 prop. Battery 2200mah 3S 35C.. (as above, I tend to like this setup)Mine is coming in at 863g bare (no painting or WBPU). Needed a bit of lead in the nose to balance. With this set up it is not as zippy as the Jaguar bet still has good performance.I think this fly’s a little more stable than the Shumate F-15 which is high praise indeed.

  2. Tobias Gaus

    Nice Flyer. Have build it also
    for the TopGun contest 2019. I‘m using a CS70mm EDF on 4S3300mAh. Don‘t try to fly it without the cheater. I have tested it and it does not work 😉. Instead of the CS fan I do recommend to use either a FMS or FW 4S 70mm Fan…….

Add a review

Your email address will not be published. Required fields are marked *